Arcadia Creek Roofing Call (269) 386-5985

Leak proof roofing in Kalamazoo

A leak proof roof in Kalamazoo is really a stack of layers: sound decking, an ice barrier at the eaves, underlayment over the rest, metal at the edges, flashing wherever the roof meets something, and shingles on top. Leaks almost always come from a missing or failed layer, not from the shingles themselves.

Last checked November 16, 2026 · 6 min read

Nobody can honestly sell a roof that will never leak. What a homeowner can ask for is a roof where every layer is present and each one backs up the one above it, so that when something fails, as something eventually does, the water meets a second line instead of the ceiling.

The layers, from the deck up

Decking. Plywood or OSB on newer houses, plank boards on a lot of older Kalamazoo and Vicksburg stock. Soft or delaminated sheets do not hold nails, and a shingle that cannot be nailed tight is a shingle that lifts. Decking is only seen when the old roof is off, which is why a quote should say what happens if bad sheets turn up.

Ice barrier at the eaves. A self adhering membrane that seals around every nail driven through it. The model code that the Michigan Residential Code follows calls for it wherever ice has a history of forming along the eaves, and asks that it run from the lowest edge of the roof to a point at least 24 inches inside the exterior wall line (International Code Council, IRC 2021, section R905.1.2). Southwest Michigan is squarely that kind of place.

Underlayment over the rest. Felt or, more often now, synthetic sheet. It is the layer that catches wind driven rain that gets past a lifted tab. On low slopes between 2 in 12 and 4 in 12 the same code doubles it (IRC 2021, section R905.2.2), which matters on porch roofs and the shallow additions common on older houses.

Drip edge. Metal at the eaves and rakes that throws water clear of the fascia and into the gutter. Without it, water curls back under the first course and into the edge boards, which is how the rot on the soffit and fascia page gets started.

Flashing. Step flashing woven into each course where a slope meets a wall, counter flashing let into the mortar of a chimney, a lined valley, and boots around pipes and vents. This is where most of the skill on a roof sits, and where most of the shortcuts are taken.

Shingles, last. They are the visible part, and they do a good job of shedding water that runs downhill. They are not a seal. That is the job of everything listed above.

Leaks that are not ice dams

Winter leaks get most of the attention in this county, and the ice dam page covers them. The leaks that turn up in a July thunderstorm usually have different causes.

Chimneys on older houses. Brick chimneys on pre war houses in the city, Otsego and Plainwell often carry flashing that was patched with roofing cement rather than replaced. The cement cracks, and water runs down the inside of the brick and shows up as a stain beside the chimney breast.

Valleys under trees. Oak and maple litter packs into valleys, holds water and pushes it sideways under the courses. An open metal valley that is kept clear sheds better than a woven one buried in leaves.

Pipe boots and vents. The rubber collar on a plumbing vent hardens and splits long before the shingles around it wear out. It is one of the cheapest repairs on any roof.

Skylights. Many leak at their own flashing kit or at the seal between glass and frame, not where they meet the shingles. It helps to know which before anyone starts pulling up the roof around one.

Lifted shingles after wind. A tab that has unsealed lets rain in sideways. The wind and storm page explains why ridges and rake edges go first.

Full membrane, or eaves only?

Some homeowners ask for self adhering membrane over the whole deck, on the reasoning that more seal must mean fewer leaks. On a complicated roof with many valleys, or a low slope section, extra membrane in those places can make sense. Over a whole deck it is a trade off. The membrane does not breathe, so on a house with a poorly ventilated attic it can trap moisture in the decking from below. Fixing the attic first is the better order, and the tear off and reroof page covers ventilation on a reroof.

What to ask on the quote

How far up the slope the ice barrier runs, and whether valleys get it too. What underlayment goes over the rest. Whether the drip edge is new at both eaves and rakes. Whether step and counter flashing are being replaced or reused, and how the chimney will be done. What happens, and at what price, if decking turns out to be soft. A company that answers those plainly is describing a roof with every layer in it.

Enquiries from this page go to a single independent roofing business covering southwest Michigan.

Call (269) 386-5985 Send details

Questions people ask

Is any roof really leak proof?

No, and a company promising one is overselling. What you can have is a roof where every layer is present, so that when one detail fails the water meets a second barrier rather than the ceiling.

Does Michigan require ice and water shield?

The model code behind the Michigan Residential Code calls for an ice barrier where ice has a history of forming at the eaves, running at least 24 inches inside the exterior wall line (IRC 2021, R905.1.2). Kalamazoo County is that kind of place. Your building department can confirm what it inspects.

Why does my roof leak in summer storms but not in winter?

That points away from ice dams and toward flashing, valleys, pipe boots or a skylight. Wind driven rain finds those details, while winter leaks usually start at the eaves.

Should the whole deck be covered in membrane?

Usually not. Eaves, valleys and low slope areas benefit most. Over a whole deck the membrane can trap moisture if the attic is poorly ventilated, so sort out ventilation first.

What is the roof doing

Answer these and a single southwest Michigan roofing business gets in touch. Nothing is sold on, and nobody else is handed your details.

Rather talk it through? (269) 386-5985

Your note goes to a single Kalamazoo County roofer for this request, nothing more. Every company that touches it is named on the privacy page.

Call (269) 386-5985